The treatment method of sticking Mould in the process of liquid silica Gel injection Molding

The development achievements of the silicone industry in recent years, especially the increasing maturity of liquid silicone injection molding technology, make it impossible for people to leave the development of application technology, and gradually make liquid silica gel in military medicine clinical application fields such as aerospace, artificial organs, new energy industry, intelligent robots, medical devices, power industry flame retardant materials, such as mechanical buffers, consumer electronics waterproof silicone parts. 

A variety of silicone products are more widely used and have been very mature. 

Then we talk about this topic. The common problem of liquid silica gel in the production process is the adhesion of liquid silica gel injection mold and product, commonly known as sticky mold, or special reasons lead to demoulding difficulties, need to rely on physical methods such as auxiliary demoulding, this process can directly lead to inefficiency, seriously affect the injection molding speed of liquid silica gel produced by equipment, and have a great impact on product quality. 

For example, when the silica gel product is deformed, the physical removal of the silicone waste of the sticky mold can easily cause mold damage, resulting in low equipment production efficiency, high labor cost, low product yield and short mold life. and the mold may need to be repaired.

Traditional cleaning method of liquid silica gel mould. 

The traditional way of cleaning and sticking mold is removed with potion, and the flying edge of the parting surface is also removed with potions or brushes, but when it comes to transparent products, the mold is polished as a mirror, the traditional one can only be scrubbed with a little bit of cotton pad, and a professional polishing master is needed, otherwise the mold will be scratched directly, and the flying edge of the parting surface can only be picked with a toothpick, so the efficiency can be imagined. 

Even the cleaning efficiency of ordinary silicone products with potions is low, which usually takes about 30 minutes.